Gaslands Smoke Trails
I wanted something to show when a vehicle had either floored the accelerator or stamped on the breaks, so I designed these Smoke Trails.
They were printed on the Creality CR-10 in PLA at a 0.2mm layer height using a 20% infill.
There are two versions, on with a small base and the other with no base. If your players tend to bump or jostle the table, I’d go with the based versions.
At some point in the future I may give it a go to create some curved smoke trails, so that we can simulate burning doughnuts or figure-of-eights, etc.
You can find these on Thingiverse as Gaslands Smoke Trails.
A saltbeard Grognard who's glad he never grew up enough to lose his imagination.